reset command-event back to normal?
Posted: Fri May 08, 2015 6:14 pm
Hi,
is it possible to reset command-event to normal, after having installed a special handler?
I have tried to reset it by setting it back to an fn which just returns a string, but I get a SIGSEGV if I do it.
Kind regards,
Ingo
is it possible to reset command-event to normal, after having installed a special handler?
I have tried to reset it by setting it back to an fn which just returns a string, but I get a SIGSEGV if I do it.
Kind regards,
Ingo