Page 1 of 1

Just starting with newLISP

PostPosted: Tue Mar 17, 2015 6:31 pm
by mcc
Hi,

greetings to all :)
This is my first posting...

Just a few minutes ago I got newLisp compiled on my Gentoo Linux PC and on my Arietta.G25
(http://www.acmesystems.it/arietta), qhich is *very* nice since anything else Lisplike failed
on my Arietta.

Before I dig deeper into this language:
I am a BIG fan of the vim editor and would like to know, whether there are any hints and tricks how
to combine newLisp and vim in a most efficient (wonderful?) way for writing newLisp-code and run
it.

How can I do this?

Best regards,
mcc

Re: Just starting with newLISP

PostPosted: Tue Mar 17, 2015 11:30 pm
by Lutz

Re: Just starting with newLISP

PostPosted: Wed Mar 18, 2015 1:56 am
by TedWalther
vim support in newLisp is good, but it would be nicer if the paren-matching code knew enough to not count parens inside strings. That completely messes paren-matching up. Also auto-indent could be a little nicer, I never did figure out how to get it working to my satisfaction.

But for the most part, paren-matching in vim is good and I use vim every day to edit newlisp.

Re: Just starting with newLISP

PostPosted: Mon Mar 23, 2015 1:50 pm
by hilti
mcc wrote: is *very* nice since anything else Lisplike failed
on my Arietta


Look's like an impressive small hardware. How's the performance?

Cheers
Marc

Re: Just starting with newLISP

PostPosted: Mon Apr 13, 2015 5:51 am
by protozen
Hey this is interesting, I never heard of it before.

hilti wrote:
mcc wrote: is *very* nice since anything else Lisplike failed
on my Arietta


Look's like an impressive small hardware. How's the performance?

Cheers
Marc